![]() This particular grade separation would also make an attractive, rustic paneling. The sapwood is liable to attack by furniture beetle and the heartwood is resistant. Soft Maple lumber is inexpensive and was commonly used for upholstered furniture frames. The sapwood is a creamy white with a slight reddish brown tinge, and the heartwood varies from light to dark reddish brown. American Hard Maple is slightly durable and is resistant to heartwood decay. Steam Bending Relatively poor choice for steam bending Drying A moderate kiln schedule can be used for drying Shrinkage Total volumetric shrinkage of silver and red maple is relatively low when compared to the other hardwoods. Red maple isa relatively strong wood, whereas silver maple is not. In the lumber trade, soft maple is used to distinguish these two species because they are lighter and “softer” than hard or sugar maple. Strength Silver maple weighs about 33 pounds per cubic foot while red maple weighs about 38 pounds per cubic foot. Anatomical and Microscopy Image courtesy of Image courtesy of ĭiffuse-porous Rays: Ray width 1 to 3 cells Parenchyma: rare, banded (marginal) Wood Properties Workability In terms of planning, shaping, turning, and boring,the wood of soft maple is rated medium to below average in comparison to the other woods reported here. Soft maple commonly has light brown streaks along the grain. Soft maple can develop a beautiful curl just like it's hard maple counterpart. Wood Species: Maple 3/4-in x 4-ft x 8-ft Maple Sanded Plywood Model 712846 Find My Store for pricing and availability 140 Actual Dimensions: 0.703-in x 4.039-ft x 8. The contrast between the white sapwood and dark heartwood is more distinct in red maple than silver maple. The sapwood is white and wide the heartwood is a light brown or pink with a grayish or greenish cast. The largest red maple is 7.3 feet in diameter at 4½ feet above the ground. The largest silver maple reported is 7.8 feet in diameter at 4½ feet above the ground. ![]() Both species are medium-sized trees from 50 to 80 feet tall and two to three feet in diameter. Most of the silver maple is produced in the Mississippi Delta and central states region while red maple dominates more to the east. Like silver maple, it can be found in swampy sites as well as on drier sites with white pine and other northern hardwoods in the northeast. Red maple has a reduced western range but grows throughout the eastern United States including the coastal regions. The pith is shown near the center of the piece. Board 6 is quartered and cut from the very heart of the log. Board 5 shows the characteristic holes and flagging from the Columbian Timber Beetle. Pith flecks are usually much more common in soft than hard maple. Numerous pith flecks are present in all pieces. Or by tree type: Ambrosia Maple Birdseye Maple Curly Maple Quilted Maple Soft Maple. Boards 3 and 4 show characteristic knots and color variation between heartwood and sapwood. The sapwood of soft maple is typically not as white as hard maple. Board 1 is all sapwood and Board 2 contains a section of darker flesh colored heartwood, typical of silver maple. Boards 1 and 2 represent the best the species has to offer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |